LIRC Raspian IR Infrared
How to set up LIRC on Raspbian Buster (2019, 4.x kernel)
How to set up LIRC on Raspbian Buster (2019, 4.x kernel) - LIRC_Raspian_Buster.md
262588213843476
GitHub - davidea72/edir_1
Contribute to davidea72/edir_1 development by creating an account on GitHub.
davidea72
Infrared Remote » Raspberry Pi Geek
Infrared Remote
Aaron Shaw
Read/emulate Remotes With Arduino and Raspberry Pi
Read/emulate Remotes With Arduino and Raspberry Pi: Remotes are everywhere. They are the interface to your TVs, music systems and what-not. You probably have a few spare ones lying around, devastated at the demise of their better halves. Cheer them up and put them back into use! (Skynet approves...…
Instructables
https://www.raspberrypi.org/forums/viewtopic.php?t=235256
Used this for first try at ir sensor with lire
Broke IR led from electro dragon EDIR
Attached wires
Attached Anode to 3.3v
Connected Cathode to Pin 25
Switched /etc/lirc/lirrc_options.conf so device is lirc0
Not sure why I have to switch to lirc1 for receiver
How can I have both
Sudo Copy the quadmultiviewhdmi.lircd.conf to /etc/lirc/lircd.conf
sudo systemctl stop lircd
sudo systemctl start lircd
irsend SEND_ONCE multihdmi KEY_F
``